For folk med saltvand i blodet....
https://www.saltvandsforum.dk:443/
Nej desværre.christiantt skrev:Resetter den ikke når du hiver stikket ud??
Jeg har tidligere haft en til repration, og da jeg fik den tilbage var alle indstillingerne der stadig.thyme skrev:Nogen gange skal hardware have 5-10 min for at det resetter rigtig, sådan er det tit med routere osv.
Men findes der ikke en online manual?5.1 The reset function
As a general principal you should always carry out a so-called Reset. This erases all
former programming and returns the system to its original condition. Please proceed
as follows:
· Disconnect the aquastar from the power supply
· Now press the key labelled F1 and keep it pressed.
· Reconnect the power supply (continue to keep F1 pressed)
The following message appears on the display shortly afterwards:
· Press the F1 key again (or press esc to abort and return to the main menu)
· After a few seconds a successful Reset will be confirmed with the message below:
· You will then be returned to the main menu.
Tak for hjælpen.wrang skrev:DU skall trycka in knappen F1 då den startar upp efter att du ryckt ut sladden så kommer det upp reset
Visst finns en Manual på nätet
http://www.iks-aqua.com/download/1000_Manual_GB.pdf
5.1 The reset function
As a general principal you should always carry out a so-called Reset. This erases all
former programming and returns the system to its original condition. Please proceed
as follows:
· Disconnect the aquastar from the power supply
· Now press the key labelled F1 and keep it pressed.
· Reconnect the power supply (continue to keep F1 pressed)
The following message appears on the display shortly afterwards:
· Press the F1 key again (or press esc to abort and return to the main menu)
· After a few seconds a successful Reset will be confirmed with the message below:
· You will then be returned to the main menu.
